![]() ![]() prise de courant n’est pas disponible, ou mural marche correctement.APC's Back-UPS® ES series is now "greener" than ever. Guide de dépannage Problème Cause probable Solution Le Back-UPS ES ne s'allume La batterie est débranchée et l’alimentation de la Branchez la batterie (voir Branchement de la batterie) et assurez-vous que la prise de courant pas. 1 3Remettez la batterie dans le compartiment. REMARQUE : Des petites étincelles peuvent apparaître lorsque vous branchez la batterie. ![]() Le UPS ne marchera pas dans cet état vous devez brancher le fil sur la borne correspondante de la batterie avant de pouvoir l’utiliser. ® ® Back-UPS ES 450/550G Guide de l’utilisateur w w w.apc.com Branchement de la batterie Pour des raisons de sécurité, le Back-UPS ES est fourni avec une batterie dont l’un des fils est débranché. Si la batería se encuentra conectada y no existe energía eléctrica energía eléctrica o la energía eléctrica disponible, se puede realizar un “encendido en frío” (utilizando la energía de la batería) presionado e ![]() tomacorriente de pared no proporciona proporcione energía eléctrica. Resolución de problemas Problema Causa probable Solución El Back-UPS ES no La batería está desconectada, el Conecte la batería (consulte Conexión de la batería) y asegúrese de que el tomacorriente de pared enciende. Voltee el Back-UPS ES y presione el pestillo de Conecte el cable de la batería de Coloque nuevamente la batería en el 1 1 2 3 comp NOTA: Es posible que se produzcan algunas chispas durante la conexión de la batería. La UPS no funcionará hasta que se conecte el cable al terminal de la batería seguro al tacto. ® ® Back-UPS ES 450/550G Guía de usuario w w w.apc.com Conexión de la batería Por razones de seguridad, se envía el Back-UPS ES con un cable de la batería desconectado. unavailable at the wall outlet, or utility power is battery is connected and power is unavailable, the unit can be “cold started” (operated on having a “brownout” or an “over voltage” battery power) by holding the power button down until two beeps are heard. Troubleshooting Problem Probable Cause Solution Back-UPS ES will not turn The battery is disconnected, and either power is Connect the battery (see Connect Battery) and ensure power is available at the wall outlet. Slide the plastic battery cover off of the Turn the Back-UPS ES over and press in the Connect the battery wire firmly to the Insert the battery back into the compartment. NOTE: Small sparks may occur during battery connection. The UPS will not operate until the wire is connected to the touch-safe battery terminal. ® ® Back-UPS ES 450/550G User Guide w w w.apc.com Connect Battery For safety, the Back-UPS ES is shipped with one battery wire disconnected. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |